Desk Hager Door Hinges

Author: Rosemary J. Johnson | Categories: Door Hinges comments
Small Hager Door Hinges

Hager door hinges have been around for a very long time. Early hinges were made of leather or fabric straps. Only the front half of the pipe hinge could be seen because the hinges were recessed at the edges of the lid or door and the inner edge of the individual cases. Plain butt hinges would be stained with wood to further melt in.

Early Desk Hinge

One of the earliest desk Hager door hinges was used where the hinge was piped. In this model, two interconnected metal sheets would wrap around a single point of turning. The material in the selection was wrought iron. A skilled iron worker could fake, cut and hammer iron in any form. The molten mineral fibers found in wrought iron made it extremely durable and surprisingly rusty. Early iron hinges were mounted on the desk cover surface and individual cases in H, T and Butterfly shapes. A large number of nails, partially hammered and then bent, held hinges in place until the arrival of screws in the 18th century.

RELATED:   How to Use Door Hinge Cutter

Brass Hinge

During the 17th century, the use of brass came to grace. The furniture was more refined and less rustic. Brass had a more sensitive and artistic appearance than the older wrought iron. As an alloy of copper and zinc, brass was easily molded, ground and polished. Until the 20th century, brass was used. Later pressed brass was assumed because it was cheaper to form. Today’s high-quality desk Hager door hinges use stronger, longer-lasting hinges made of extruded brass.

RELATED:   The Best Ideas Concealed Door Hinges

Comments are closed. -->